Page 1 of 1

Replace rubber roof trim

Posted: Mon Mar 08, 2010 8:34 pm
by ollielloyd
Rubber strips that run length of roof on both sides are bit discoloured.

Anyone know where I can get these?

Re: Replace rubber roof trim

Posted: Tue Mar 09, 2010 11:07 pm
by ollielloyd
Can nobody help?

Re: Replace rubber roof trim

Posted: Thu Mar 11, 2010 10:54 pm
by Hawkins
Honda dealer

Re: Replace rubber roof trim

Posted: Thu Mar 11, 2010 10:58 pm
by mat
i hope you are sitting down....


they are about 40 quid each from honda!



mat.

Re: Replace rubber roof trim

Posted: Fri Mar 12, 2010 12:36 am
by ollielloyd
Must be available elsewhere for less?

Re: Replace rubber roof trim

Posted: Fri Mar 12, 2010 7:32 am
by mjhamilton
have you tried a decent cleaner for bubber?.. Autoglym and Meguiares to one... I would remove these unless they are totally shagged as you will potentially be forever chasing leaks in the future

Re: Replace rubber roof trim

Posted: Fri Mar 12, 2010 8:48 am
by ollielloyd
Can anyone recommend a decent one?

Re: Replace rubber roof trim

Posted: Fri Mar 12, 2010 11:04 am
by mjhamilton
ollielloyd wrote:Can anyone recommend a decent one?
I recommended 2 above.. :scratch:




but here goes anyway :thumbup:

http://www.performancemotorcare.com/aca ... _1380.html

http://www.performancemotorcare.com/aca ... ailer.html

http://www.performancemotorcare.com/aca ... r__40.html

Re: Replace rubber roof trim

Posted: Fri Mar 12, 2010 11:07 am
by mat
mjhamilton wrote:
ollielloyd wrote:Can anyone recommend a decent one?
I recommended 2 above.. :scratch:




but here goes anyway :thumbup:

http://www.performancemotorcare.com/aca ... _1380.html

http://www.performancemotorcare.com/aca ... ailer.html

http://www.performancemotorcare.com/aca ... r__40.html
i concur, AG bumper care is a very good product, you may have to apply it several times though if the fading is that bad.


mat.

Re: Replace rubber roof trim

Posted: Fri Mar 12, 2010 11:19 am
by FireBIade2
I use Autoglym Vynl and Rubber care

Wash and dry your car then go over the black plastic and rubber bits with this stuff, makes it look :cooldude: and keeps it protected! Repeat every 3-6 months.