Civic Type-R Owners Club & Forum

Hi guys I'm planning on making a sidewinder turbo manifold with the help of a friend and was after some advice .

So far I've just bought the

-K20 head flange
-T3 flange
-44 mm v band flange

Now some of the questions I had are is sch 10 pipe acceptable or is sch 40 more wise ?

For anyone that's made there own how did they go about making it exactly. We was planning on borrowing a sidewinder that we can make a jig of so that we can make ours off

I would check what off the shelf manis are made from. Fairly sir it's sch40 for a good one like

Would seriously recommend just buying a CNC billet collector with the gate flange already fitted

jonezy wrote:I would check what off the shelf manis are made from. Fairly sir it's sch40 for a good one like

Would seriously recommend just buying a CNC billet collector with the gate flange already fitted

have done......they are about £300 though

1812_s wrote:

jonezy wrote:I would check what off the shelf manis are made from. Fairly sir it's sch40 for a good one like

Would seriously recommend just buying a CNC billet collector with the gate flange already fitted

have done......they are about £300 though

For an extra £200 you could of bought a complete manifold made by solid fabrication...

Lewisgame wrote:

1812_s wrote:

jonezy wrote:I would check what off the shelf manis are made from. Fairly sir it's sch40 for a good one like

Would seriously recommend just buying a CNC billet collector with the gate flange already fitted

have done......they are about £300 though

For an extra £200 you could of bought a complete manifold made by solid fabrication...

Yep but I'm not paying for a cnc collector

Give me a couple of days, last lie of CNC collectors I saw were about the £170 mark

Added in 2 minutes 32 seconds:
This may take me some time

Last days it wa defiantly in my feed on FB

Will repost if I find it

jonezy wrote:Give me a couple of days, last lie of CNC collectors I saw were about the £170 mark

Added in 2 minutes 32 seconds:
This may take me some time

Last days it wa defiantly in my feed on FB

Will repost if I find it

Any luck

Annoyingly no. It was one of those ads in the middle of Facebook so naturally can't find it now

ss autoworks or werks were doing those collectors

baddohc wrote:ss autoworks or werks were doing those collectors

Yes have contacted them already.... £290

Shame.

I have tried everything, cannot find em

Adi-R wrote:http://elmerracing.com/raceshop/exhaust ... ess-detail

That's tasty looking, wouldn't use it though, it's so short you won't get a good angle for the wastegate and will very likely have boost creep.

Made a jig now using a fullrace manifold so will soon be making the manifold

Won't go far wrong ripping off a fullrace lol

jonezy wrote:Won't go far wrong ripping off a fullrace lol

Drop us a PM if you got any turbo queries.