The largest Civic Type R club forum

Established in 2002 it brings together people from all over the world to discuss their one love of Type R's.

Got a question/comment about another marque? Ask in here.
User avatar
By JC600
#3860566
Remote idle speed control valve and new brake reservoir cap have arrived. Will get them fitted one night this week. 

The holes are already in the inner wing, so that makes it easier. Hopefully my idle problems will be resolved and my brake fluid leak.  :) 

Image
User avatar
By JC600
#3860589
New reservoir cap fitted, and remote idle speed control valve fitted. :) 

Set idle speed at 850rpm, returns back 850rpm after revving the engine. No stalling when dipping the clutch and idles loads better, smoother too. So all good so far. Just need to take it for a test drive after I finish call. :) 

Image

Image
User avatar
By JC600
#3860601
Exhaust clip from my MK4 with 1.6efi cvh with 2" bore down pipe back stainless steel exhaust.  :D


​​​​​​
And the engine idling nicely after fitting the remote idle speed control valve. :) 

User avatar
By JC600
#3860660
Took the Escort for a good 40 mile drive this morning, idle is spot on now. So can stop and drive off properly now. Seems to be a bit quicker too. :D


Definitely have no brake fluid leaks, but still had fluid on top of the gearbox. Looks like it was coming from the transmission to clutch housing bolt. Checked the bolts, and they didn't seem that tight. So torqued them up to the correct amount. Hopefully that's sorted it. :)


Some better pic's with the ambers fitted. :D


Image


Image


Image


Image


Image


Image


Image


Image


Image


Image
User avatar
By JC600
#3860675
15repyt wrote:Still looking nice mate! Needs the spoiler still lol! just looks bare at the rear.
Cheers mate, still in two minds lol......unless I find the rare accessory rear spoiler. :)
User avatar
By JC600
#3861549
Collected a few parts today, correct airbox for the remote idle speed control valve I fitted. Genuine Ford Indicator to replace the aftermarket one I have fitted. And a coil pack cover that mine was missing. Just need a good clean before I fit them all. :) 

Image 
User avatar
By JC600
#3862945
Changed my knackered under bonnet stickers today, but used ones for a 1.6 efi engine so they are correct. :) 

Old ones

Image

Image

Image

New ones

Image

All fitted 

Image
User avatar
By JC600
#3863166
Cheers mate, getting paint and dents sorted soon. Got a 88spec XR3i spoiler to go on, will be colour coded along with mirrors. Dark Grey bottom half like lx, ghia, sport models. Rubbing strips with red insert. And a mk3 style boot sticker. Can't wait. :D
User avatar
By JC600
#3863198
Will do, these arrived the other day. :)

Image

Also picked up some rubbing strips, and ordered some 12mm red Coach line to replace the chrome in the rubbing strips. :)
User avatar
By JC600
#3863252
When I the idle control valve to the Hitachi Ford modification. I didn't realize they also replaced the ecu. The car has been idling better but every now and it started hunting. So I sourced a 1afa ecu and it arrived today. :) 

Image

Car fired up absolutely perfectly, idle was spot on. Even know the battery had been disconnected. 

Got up to temperature, and fans didn't kick in. Done ecu reset procedure. Still no fan. Switched off engine, before it got to the red. So I could bridge the fan switch plug. And the fan switch fell apart in my hand. Checked fan still, and all working. Just need a new switch. :) 

Think it's past its beat lol

Image

Image
User avatar
By JC600
#3863299
New fan switch arrived. :D

Image

Fitted

Image

And a little video clip of how it's idling now, and a rev up lol. :D



Just can't drive it till next weekend, as I'm on call. :(
  • 1
  • 3
  • 4
  • 5
  • 6
  • 7

Long time ago I had and Ep3 for 220k kilometers in[…]