Aux belt tensioner question?
Posted: Wed Feb 11, 2015 5:17 pm
Hi guys just replaced the aux belt and top pulley on my motor as they bolt looked worse for ware, looking at the manual it suggested that the arrow on the auto tensioner should be dead centre of the two squares.... although looking at mine its on the outside edge of the largest square. The items were both purchased from lings honda
Part numbers are,
38920-PRA-013 (BELT)
PFKL464888 (PULLEY)
[/URL]
Any ideas if this will stretch in or should i be concerned? I originally ordered a belt from Jap service parts which fit but was so tight it wouldn't crank over so i sent it back and ordered from honda. It now starts just fine but I'm a little concerned.
Any help much appreciated
Lloyd
Part numbers are,
38920-PRA-013 (BELT)
PFKL464888 (PULLEY)
[/URL]Any ideas if this will stretch in or should i be concerned? I originally ordered a belt from Jap service parts which fit but was so tight it wouldn't crank over so i sent it back and ordered from honda. It now starts just fine but I'm a little concerned.
Any help much appreciated
Lloyd