The Worlds Largest Independent Honda Type-R Club & Forum - "Often imitated, never duplicated" 

  • Replacing Front Drop Links

 #3866134  by jafwatt
 Mon May 21, 2018 1:28 pm
Next weekend I'll be replacing my front drop links. I had expected the old ones to have a hole in the bolt for a hex key to hold it in place while the nut turns but the ones I have fitted don't have this and there are no flat spots either.

Does the back of the link's bolt locate into the wishbone/ARB to stop it turning? Just planning ahead so I don't get any nasty surprises like spinning bolts I'll have to grind/drill out.


Added in 2 hours 33 minutes 53 seconds:
Here's a pic of the top bolt on the left side.
You do not have the required permissions to view the files attached to this post.
 #3866180  by 15repyt
 Sun Jun 10, 2018 3:43 pm
Just wire brush the thread and use wd40. Then clamp thin nose mole grips to the back very tight and undo the nut.