The largest Civic Type R club forum

[trancem]

This?



If so, you need part 6 below



About £7 from Honda, or use the one off your OEM hose, but it's a PITA to get off

[Mickey C]

I had a k&n typhoon on before and I don't have one


Oh ffs

[Mickey C]

And the actual intake is sitting about 2 inches away from the scuttle typical when I try DIY

[Mickey C]

help me bro's

cant get this in... missing something ?



were it should be...



what the deuce...

[Mickey C]

also this came off a pre-facelift and he had the left hole bolted off ?

[Settez]

There should be a little metal connector that goes inside the two pipes as said above. Not sure what this is for though or how vital it is??

[Settez]

oh and regarding the fitment of the sfs, just connect it to the intake then move the whole thing. Doesn't need to sit as high as you have it, mines a fair bit lower than that.

[trancem]

See my post above chaps, part no. 6

[Mickey C]

What happened is my sfs hose has been cut down i think to fit another manifold, as id bought this kit of another forum memeber and he has a different one.

Not to worry im just going fit it to a standard intake hose and ill get the little metal thing i need with it too

[bluntcap]

What happened is my sfs hose has been cut down i think to fit another manifold, as id bought this kit of another forum memeber and he has a different one.

Not to worry im just going fit it to a standard intake hose and ill get the little metal thing i need with it too

yep your SFS hose has been trimmed to fit an RBC mate.

And as above the fellas have sorted you out with the part you 100% are missing.

[Mickey C]

hes giving me a brand new oem intake hose tomorrow, was proper frustrated trying to work out why it wouldnt fit

[1534walla]

the metal piece your missin is off the oem intake hose

you have to reuse it for the silicone one...just get some pliers on it and pull it out

[Mickey C]

finally got it in, probably not the tidiest fitment but its working :WOOT

[trancem]

Looking good mate [smilie=karls_thumb.gif]

[bluntcap]

Nice dude [smilie=karls_thumb.gif]

[Stevo M81]

All you need now is a SFS or Tegiwa red hose [smilie=karls_thumb.gif]

[Settez]

http://www.civictype-r.co.uk/forum/view ... 4&t=252238

:bigthumb:

[Mfisher]

What goes onto the right hand side breather bit on the intake pipe?

[bluntcap]

What goes onto the right hand side breather bit on the intake pipe?

It's a sensor mate to give readings of the air flow to the ECU

[Mfisher]

Thanks dude!

What goes onto the right hand side breather bit on the intake pipe?

It's a sensor mate to give readings of the air flow to the ECU